triax icp® force sensor, 10k lb (fz), 4000 lb (fx,y), 0.25 mv/lb (z), 1.25 mv/lb (x, y)

3-Component ICP® Force Sensor

Model 260A03

Retrieving Price...

(Pricing valid only in the U.S.)

Units in Stock Lead Times
1 Call for Lead Time
  • CE
  • IP

Triax ICP® force sensor, 10k lb (Fz), 4000 lb (Fx,y), 0.25 mV/lb (z), 1.25 mV/lb (x, y)

  • Temperature Range: -65 to +250 °F (-54 to +121 °C)
  • Electrical Connector: 4-Pin

Specification Notes


[1] Zero-based, least-squares, straight line method.
[2] Typical.
[3] Sensitivites are for listed preload. Sensitivites may vary ±5% depending on preload used.
[4] Sensitivities are dependent upon supplied bolt.
[2] Typical.
[5] Preload should be at least 10 times the X and Y operating range used.
[6] See PCB Declaration of Conformance PS023 for details.

English: SI:
Performance
Sensitivity (±20 %) (Z Axis) 0.25 mV/lb 0.06 mV/N [3] [4]
Sensitivity (±20 %) (X or Y Axis) 1.25 mV/lb 0.28 mV/N [3] [4]
Measurement Range (Z Axis) 10000 lb 44.48 kN
Measurement Range (X or Y Axis) 4000 lb 17.79 kN
Maximum Force (Z Axis) 11000 lb 48.93 kN
Maximum Force (X or Y Axis) 4400 lb 19.57 kN
Maximum Moment (Z Axis) 240 ft-lb 325.4 Nm
Maximum Moment (X or Y Axis) 325 ft-lb 440.6 Nm
Broadband Resolution (Z Axis) 0.05 lb-rms 0.222 N-rms [2]
Broadband Resolution (X or Y axis) 0.01 lb-rms 0.044 N-rms [2]
Upper Frequency Limit 39000 Hz 39000 Hz
Low Frequency Response (-5 %) (Z-Axis) 0.01 Hz 0.01 Hz
Low Frequency Response (-5 %) (X or Y Axis) 0.001 Hz 0.001 Hz
Non-Linearity ≤1 % FS ≤1 % FS [1]
Cross Talk (between X and Y Axis) ±3 % ±3 %
Cross Talk (between (X or Y Axis) and Z Axis) ±5 % ±5 %
Environmental
Temperature Range -65 to +250 °F -54 to +121 °C
Electrical
Full Scale Output (Z Direction) ±2.5 VDC ±2.5 VDC
Full Scale Output (X and Y Direction) ±5 VDC ±5 VDC
Discharge Time Constant (Z Axis) ≥50 sec ≥50 sec
Discharge Time Constant (X or Y Axis) ≥500 sec ≥500 sec
Excitation Voltage (all channels) 20 to 30 VDC 20 to 30 VDC
Constant Current Excitation (all channels) 2 to 20 mA 2 to 20 mA
Output Impedance ≤100 Ohm ≤100 Ohm
Output Bias Voltage 8 to 14 VDC 8 to 14 VDC
Spectral Noise (1 Hz) 0.003 lb/√Hz 0.0133 N/√Hz
Spectral Noise (10 Hz) (X & Y) 0.001 lb/√Hz 0.00445 N/√Hz
Spectral Noise (100 Hz) (X & Y) 0.0004 lb/√Hz 0.00178 N/√Hz
Spectral Noise (1000 Hz) 0.0001 lb/√Hz 0.00044 N/√Hz
Spectral Noise (1 Hz) (Z) 0.02 lb/√Hz 0.089 N/√Hz
Spectral Noise (10 Hz) (Z) 0.005 lb/√Hz 0.0222 N/√Hz
Spectral Noise (100 Hz) (Z) 0.002 lb/√Hz 0.0089 N/√Hz
Spectral Noise (1000 Hz) (Z) 0.0005 lb/√Hz 0.00222 N/√Hz
Output Polarity Positive Positive
Physical
Preload 40000 lb 178 kN [5]
Stiffness (Z Axis) 38.8 lb/µin 6.8 kN/µm [2]
Stiffness (X or Y Axis) 11.4 lb/µin 2.0 kN/µm [2]
Size - Height 0.790 in 20.07 mm
Size - Length 2.25 in 57.1 mm
Size - Width 2.25 in 57.1 mm
Size - Bolt Diameter 1 in 25 mm
Size - ID 1.023 in 25.98 mm
Size - Sensing Surface 1.800 in 45.72 mm
Weight 9.56 oz 271 gm
Housing Material Stainless Steel Stainless Steel
Sealing Hermetic Hermetic
Electrical Connector 4-Pin 4-Pin
Electrical Connection Position Side Side

* All specifications are at room temperature unless otherwise specified.

Accessories


Supplied
081A71 Pre-load bolt (for Models 260A03, 260A13 & 260A33) 1
082B06 Anti-friction washer for Models (M)206C, (M)216B, (M)260A03, (M)260A13 & (M)260A33 1
083A11 Pilot bushing (for Models 260A03, 260A13, & 260A33) 1
M081A71 Pre-load bolt (for Models 260A03, 260A13 & 260A33) 1

Optional Versions


(W) Water Resistant Cable

English SI
Electrical Connection Position Side
Electrical Connection Position Side

Build Out Your Measurement Chain


482C24
Model: 482C24

4-channel, line powered, ICP® sensor sig...

$2,352.00 USD

(Pricing valid only in the U.S.)

010G20
Model: 010G20

4-conductor, shielded, FEP cable, 20-ft,...

$189.00 USD

(Pricing valid only in the U.S.)

M081A71
Model: M081A71

Pre-load bolt (for Models 260A03, 260A13...

$118.00 USD

(Pricing valid only in the U.S.)

081A71
Model: 081A71

Pre-load bolt (for Models 260A03, 260A13...

$118.00 USD

(Pricing valid only in the U.S.)

082B06
Model: 082B06

Anti-friction washer for Models (M)206C,...

$74.00 USD

(Pricing valid only in the U.S.)

083A11
Model: 083A11

Pilot bushing (for Models 260A03, 260A13...

$49.00 USD

(Pricing valid only in the U.S.)

261B03
Model: 261B03

Triax force link, ICP®, 10k lb (Fz), 4k ...

$5,600.00 USD

(Pricing valid only in the U.S.)